Sample Induction Protocol (for reference only)
1. Inoculate a single colony from a freshly streaked plate into 5 ml of LB medium containing the appropriate antibiotic for the plasmid and host strain.
2. Incubate with shaking at 200 rpm at 37℃ overnight.
3. Inoculate 50 ml of LB medium containing the appropriate antibiotic with 0.5 ml of the overnight culture prepared in step 2(use the 500 ml triangular flask as the container would be better).
4. Incubate with shaking at 150 rpm at 37℃ until the OD 600 reaches 0.5-0.8.
5. (Optional)Pipet 1ml of the cultures into clean microcentrifuge tubes and place the tubes on ice until needed for gel analysis or storage at -20℃. These will serve as the non-induced control samples.
6. Add IPTG to a final concentration of 1 mM. Optimal time for induction of the target protein may vary from 2-16 hours, depending on the protein.
7. Incubate with shaking at 120 rpm at 37℃ for 3-4 hours. To determine the optimal time for induction of the target protein, it is recommended that a time course experiment be performed varying the induction from 2-16 hours.
8. Place the culture on ice for 10 minutes. Harvest cells by centrifugation at 5,000 x g for 10
minutes at 4℃.
9. Remove the supernatant and store the cell pellet at -20℃ (storage at lower temperatures is also acceptable).
IPTG
Prepare a 1 M solution of IPTG (Isopropyl-β-D-thiogalactoside; Isopropyl-β-D-thiogalactopyranoside) by
dissolving 2.38 g of IPTG in dd water and adjust the final volume to 10 ml. Filter sterilize before use.
C43(DE3) 感受态细胞
注意事项
1. 感受态细胞最好在冰上融化。
2. 混入质粒时应轻柔操作。
3. 转化高浓度的质粒可相应减少最终用于涂板的菌量。
4. 诱导时，IPTG浓度可选（0.1-2mM均可）。
5. 为获得需要量的蛋白，最佳诱导时间，温度，IPTG浓度需实验者优化。
GV3101感受态细胞火热促销中》》》